ARCHER PLUS SR10+

Note: Please ensure you are using the v3.0.0 (or later versions) Lua scripts to configure the Stab device with flashed this firmware version. The older Stab Lua tools or the Stab tools in Device Config (ETHOS’s integration) are not compatible.

1. Added the Reset function to recover the Stab settings to the factory settings.
2. Added the AUX mode option to each Stab channel.
3. Cancelled the operation requiring putting the Throttle stick to the lowest (＜1000us) while doing the Self-Check.
4. Added the Stick Priority function for Stab channels
Notice: Please reset your stab device (by Lua tool) after flashing with this firmware version, and reconfigure it to make sure it can work properly.
Please read the instructional manual to ensure the self-stabilization function works properly. Click and Read → Manual

1. Fixed the compatible issue of the receiver working with the Stab Lua scripts while running on some OPTX radio models (Taranis X9D Plus, etc.)

1. Added Pitch and Roll angle control for stabilization mode.
2. Fixed the telemetry error of the Pitch and Roll angle in the calibration process after repowering.
3. Fixed the issue that the Pitch angle sometimes fails in Hover mode.
4. Reduced the effect brought by vibrations for the stabilization function.
5. Fixed the issue of outputting a jitter signal while connecting or hot-swapping a redundant receiver by SBUS port.

1. Added the second group of stabilized 5 channels in ACCESS mode.

1. Added the support of S.Port function via Upgrade Port in ACCST mode.
2. Added support for working with RB25 and RB35 series devices.