0:25 – Remove the battery and remove the 4 screws to open the radio
0:55 – Install the M7 with the sensors towards the outside
1:20 – To release the centering on the throttle axis place the provided screw into the hole to disable the spring
1:55 – Adjust the tension by tightening these plates
2:15 – Again place the sensor to the outside
2:59 – Calibrate the sticks by following the directions on the screen, make sure to move the sticks with normal pressure.
0:55 – Install the M7 with the sensors towards the outside
1:20 – To release the centering on the throttle axis place the provided screw into the hole to disable the spring
1:55 – Adjust the tension by tightening these plates
2:15 – Again place the sensor to the outside
2:59 – Calibrate the sticks by following the directions on the screen, make sure to move the sticks with normal pressure.
