| Details | File Size | Download |
|---|---|---|
| UpdateTime : 2021-02-20 Version : 20210220 |
7.27MB | DOWNLOAD |
MANUAL
FIRMWARE
FIRMWARE FOR NFC POWER SWITCH
LUA SCRIPT - OPENTX
FrSky FreeLink APP (PC)
MANUAL
FIRMWARE
| UpdateTime | Version | Notes | File Size | Download |
|---|---|---|---|---|
| 2022-04-21 | 20220412 | 1. Supports two different modes (12CH and LUA) to enter the self-check mode. 2. Compatible with TANDEM receivers. 3. Fix the issue that CH17 to CH24 would not work under stabilization mode. |
166KB | DOWNLOAD |
| 2022-03-11 | 20220124 | Customized Pin Mapping in Stabilization Mode. Note: 1. In stabilization mode, do not change the PinMAP of CH9 ~ CH12. Otherwise, the calibration mode cannot be triggered. 2. In stabilization mode, the receiver PIN1~PIN6 always outputs CH1-CH6 data(the PinMAP setting for PIN1-PIN6 is invalid) |
166KB | DOWNLOAD |
| 2021-11-01 | 20211009 | 1. Optimize the gyroscope algorithm to improve the adaptability of vibration models. 2. Add SBUS 24-channel mode (Archer receivers to be updated to work with). |
166KB | DOWNLOAD |
| 2021-05-26 | 20210522 | Optimized the logic for battery switchover. | 164KB | DOWNLOAD |
| 2021-02-03 | 20210201 | 1. Fixed an issue where the output range of CH5 and CH6 was still restricted by self-check calibration when switched to AUX channels. 2. Fixed an error in reading the Gas Suit configuration when used with the Gas Suit. |
164KB | DOWNLOAD |
| 2020-12-11 | 20201203 | 1. Solve the problem of the RB30 is powered by only one battery under low current operating conditions. Note: *Does not support the separate setting of two-way BEC. Lua script Vout1 controls both BEC, Vout2 does not take effect. * The batteries must be the same cells to offer the balancing power-supply . |
164KB | DOWNLOAD |
| 2020-10-30 | 20201028 | 1. Improve self-stabilization function. 2. When BEC=8.4V, the BEC sometimes started improperly after linking with heavy load devices. Note: It is highly recommended to upgrade. |
164KB | DOWNLOAD |
FIRMWARE FOR NFC POWER SWITCH
LUA SCRIPT - OPENTX
| UpdateTime | Version | Note | File Size | Download |
|---|---|---|---|---|
| 2021-02-03 | v1.02 | LUA files for the radios running OpenTX. Add calibration command for current sensor. |
154KB | DOWNLOAD |
| 2020-09-27 | v1.01 | LUA files for the radios running OpenTX. Fix the issue that Lua cannot work with radios with the XJT module. |
153KB | DOWNLOAD |
FrSky FreeLink APP (PC)
| Details | Note | File Size | Download |
|---|---|---|---|
| Compatiblity : STK / S.Port AirLink / S.Port AirLink S UpdateTime : 2022-02-15 Version : 3.5 |
Update for Xact servos . | 4.74 MB | DOWNLOAD |
